is it necesary to modify them once you have them , or can i just directly replace them, i doubt everyone with them
has done the mod for lhd use

It depends on a few things:
You may, blind the opposite side of the road resulting in a crash, or a fine off police.
It will help you see better on the road, but its more for safety reasons. If your not running HIDs you could get away with it probaby.

you could also just make them point a little bit lower too

ill do the point thing probably, looks too intense to do the whole mod thing



>

In the Netherlands, we have to convert them to LHD to be road-legal, so that's the main reason why I converted them.
Modification is easy but it just takes some time. Here's a short how-to of my conversion.

My new projectors


Take off the lights and all rubber parts.


Put them in the stove: 10 minutes at 120 degrees Celsius



Take off the glass


The part of the projector that has to be converted




Cutting the metall. I used a DREMEL with a grinding wheel.


Re-install the projector. Put it back into the oven so the glue becomes soft again > it's easier to re-install the glass.


I used this glue


The result





I installed Pilot HID, H1 6000 in lowbeams, HB3 6000K in highbeams and H3 6000K in the foglights.

-Roy

This post has been edited by RoyO: Dec 26, 2011 - 5:09 AM

ok thanks a lot man, really helpful