Hi all, done a lot of reading on this forum and its been a great help with my conversion.

ST202 convertible with 3rd gen 3SGTE and ST185 gearbox with MR2 Turbo box bellhousing - because I got both very cheap and the MR2 box had LSD too. Engine and box are in the car and is all running well, but I've heard that one of the axle can pop out and a spacer in needed to be machined from a old axle.

I have the part needed
But how thick should the spacer be made?
What bolts can I then use as the std bolts will not be long enough?

anybody

really need help here guys

I know that this is done and has to be done, tried the search but not found it!

same here.. i couldnt find anything...i only see pictures of the spacer but it doesnt say how thick nor how we can make one.

As far as I can tell, it's a 1/2" spacer. Lots of good information in this thread but I lost interest so I just skimmed most of it.

http://www.6gc.net/forums/index.php?showtopic=32626

you know funny thing, i have an E153 trans in my car and i didnt need a spacer. im using MR2 turbo LSD inners and ST185 outters. no issues at all