I went ahead because I needed some way to look at torque specs easily. I compiled the torque specs per BGB. Some may have redundant lines - thats due to the BGB showing it more than once.
For your ease. I can send you guys the PDF or post it somewhere but you can just download the jpegs and combine them into a PDF file relatively easy.












This post has been edited by trdproven: May 15, 2012 - 8:00 PM

Nice, very useful!

Nice - but what about the other platforms?

ie. 2.0L 3SGE rev3; Beams, etc??

Nice post! Well done. I wish I had this when I swapped.

I VOTE STICKY!!! I WILL need this sooner than later.

>

I'm not sure if I can find something for that. 1.8 and 2.2 manuals are so much easier to find. For the all trac or 3sgte, I would assume in general most of these torque specs apply and the difference would be mainly engine, trans, some suspension. i'm sure you could also use a 4th gen or 5th gen 3sge/3sgte manual in some occasions. The beams is another thing, could be similar to a regular 3sge, not to mention the beams manual was only in Japanese and is considered a collectors item.

This post has been edited by trdproven: May 15, 2012 - 8:18 PM

great stuff added

for people wanting the Gen 3: 3S-GE & GTE torque specs, they can be found in the repair manuals in the above sticky thread
(RM396E) 3S-GE Engine Repair Manual

(RM398E) 3S-GTE Repair Manual
(RM399E) ST205 Chassis and Body Repair Manual

Now the BEAMS repair manual, as pointed out was only available in Japanese and is hard/$$ to come across. I have heard of some people having it/ trying to translate it into english, also as far as I can tell it hasn't been posted up on the web. However it appears that most/all of the torque specs are the same as the Gen 3 3S-GE

Personally some of these torque specs dont seem tight enough for me.

its been confirmed on beams owners group that all 3rd, 4th, and 5th Gen 3SGE motors use the same torque specs.

Hi the head gasket has gone on my Celica st202 3sge and i was woundering what the torque settings are for the head bolts any help would be greatly accepted

Check the above sticky for the (RM396E) 3S-GE Engine Repair Manual, has all the info & torque specs for the job

bump for sticky or including this in a sticky thread

It is twice under the 7A and 5S sections

welp....double the "im an idiot for not looking hard enough" haha

hi for some reason the jpg or pdf youve listed for the torque specs are not showing and it says i need to upgrade to view it or something like that.