At the topic says looking to buy a J-Speed front strut brace. Its prob a long shot but fingers crossed. It will most likely need to be shipped overseas as I am in Sydney.
Thanks
Thanks
WTB - 6G Celicas Forums
i also want one...found some places in Japan where to order...but was a bit pricey...but they were new.
here's your answer talk to yellowchinaman here's a member here on the forums. He's recently built a 3 point front strut bar, which is better quality than the JSpeed
here you go :
http://www.6gc.net/forums/index.php?showto...t=0&start=0
This post has been edited by BonzaiCelica: May 23, 2012 - 3:20 AM
here you go :
http://www.6gc.net/forums/index.php?showto...t=0&start=0
This post has been edited by BonzaiCelica: May 23, 2012 - 3:20 AM
Group buy to replicate Narrow E series transaxle partshttp://www.6gc.net/forums/index.php?showto...p;#entry1107514
you sure it is better quality then the Jspeed...?
>
or the same
QUOTE (UndaGrwnD @ May 23, 2012 - 3:40 AM) 
>you sure it is better quality then the Jspeed...?
or the same
Group buy to replicate Narrow E series transaxle partshttp://www.6gc.net/forums/index.php?showto...p;#entry1107514