http://www.ebay.co.uk/itm/320841077436?ssP...984.m1952.l2649

But adjustable in length and pref cheaper?
Anyone know where I can buy them from?
Also end fixings must be the same.

This post has been edited by yellowchinaman: May 31, 2012 - 8:59 AM

>
ebay dude. everything is on ebay

Are you wanting to mass produce or make one set?

Go to someplace online like mcmaster-carr that carries industial hardware and look at ball joint linkages
and the connecting rods or find something similar.

Ball joint ends are kind of expensive but if I was making it myself, I would use 2 male and male HD balljoints,
2 concave aluminum washers and find some aluminum tube with the right inside
diameter to tap without drilling to fit the male end. Which would probably cost twice what they want for that set.lol

Look into other stuff with similar pieces, non automotive and heavily
mass produced to get the cheapest price.

Just by looking at the clevis hole centering on the one you posted the quality
seems pretty shabby. I think I could drink a half dozen pints o lager and get the
holes closer than that with a hand drill.

This post has been edited by 97lestyousay: May 31, 2012 - 10:13 AM

it seems as if this is the trouble part that is keeping you from completing the splitter project

>

Yes it is.