Question for my st215 caldina engine can i use any 2 bar turbo map sensor to run the engine

for example would this work http://www.ebay.com/itm/GM-2-BAR-MAP-SENSO...ff6&vxp=mtr

and just rewire to the harness

what other options do I have?

>

bump

you dont have any other options unless you had the original one to compare voltage outputs with


maybe you had many different map sensors hooked up to an air compressor with 2 bar in the line, and say.... miraculously... they all read 5 volts evenly..... (which they wont)

... then if you were to drop the pressure to 1bar.... perhaps one voltage output may drop to around 4v, another could drop to 3.7v, 3.8v, 3.9v, 4.1v, 4.2v, etc, who knows

Ok I understand