Over 1M Posts • 84K Topics • 9K Authors

Home > Topic #89650

bolt sizes? - 6G Celicas Forums

Topic #89650 6 posts Started by slo_celly
slo_celly
#1
what is the thread size for the bolts that go from the front motor mount to the bell housing?

additionally, what is the thread size for the bolt that anchors the two tranny mount sides from underneath?


...long story short, im rebuilding a celica that was horribly mistreated, and im missing some pretty important bolts... kindasad.gif
uber low budget build (with prices!)
808celica
#2
14x1.5 and 30mm/36mm long i think. make sure to get grade8 bolts laugh.gif

This post has been edited by 808celica: May 19, 2013 - 2:43 PM
I don't normally drive fast, but when I do its on a curvy section of this island
slo_celly
#3
>
QUOTE (808celica @ May 19, 2013 - 2:42 PM) *
>14x1.5 and 30mm/36mm long i think. make sure to get grade8 bolts laugh.gif


THAAANKK YOUUU. Lol. I was scratching my head there for a Minute... You just made my.life a little easier.
uber low budget build (with prices!)
Smaay
#4
im not too sure about that. for the engine mounts they are all M10 X 1.25 bolts. only the the bolts that bolt the trans to the engine are M14 X 1.5
2001 Celica GT-S Turbo1997 Supra TT 6speed1997 Celica 3MZ/1MZ swap1990 Celica All-Trac
slo_celly
#5
>
QUOTE (Smaay @ May 20, 2013 - 12:16 PM) *
>im not too sure about that. for the engine mounts they are all M10 X 1.25 bolts. only the the bolts that bolt the trans to the engine are M14 X 1.5

yup. found that out when i took THIS to the dealership.



This post has been edited by slo_celly: May 22, 2013 - 1:39 AM
uber low budget build (with prices!)
k-weaver
#6
I usually just hit the dealer for missing items like bolts. Usually a couple bucks each but knowing you got the right size and grade makes it worth it to me.
← Back to Topics