asking $3000 obo
227k miles runs great
The good
Drilled and slotted rotors and ceramic pads on all corners @ 215k
fully rebuilt front suspension professionally installed @ 207k
Eibach sportline springs and new struts on all corners @ 207k
4 wheel Alignment @ 207k
Performance header
new clutch, axles, wheel bearings @ 195k
new motor mounts @ 180k
7th gen GTS wheels
alpine power pack audio amp upgrade
4 alpine 6 1/2 two way speakers
kicker 250w sub amp
2 kicker 10" subwoofers in ported enclosures
the bad
slight oil leak maybe the valve cover gasket
slight power steering leak from the rack on the passenger side, sale would include a new rack i just haven't had installed yet
no radio
would need a new radio bezel surround
convertible top needs to be recovered (doesnt leak but the stitching on the edges is weakening)
convertible top needs the motor pins fixed, motors work but won't lift the top without the stress pins replaced
check engine light on for egr insufficient flow since the header was installed.
catalytic converter was straight piped (only bad if you need to inspect for emissions)
pics can be found on my project page linked on my signature
top is currently tan after replacing the convertible top frame
This post has been edited by b22ri22an: Feb 13, 2014 - 2:15 PM
227k miles runs great
The good
Drilled and slotted rotors and ceramic pads on all corners @ 215k
fully rebuilt front suspension professionally installed @ 207k
Eibach sportline springs and new struts on all corners @ 207k
4 wheel Alignment @ 207k
Performance header
new clutch, axles, wheel bearings @ 195k
new motor mounts @ 180k
7th gen GTS wheels
alpine power pack audio amp upgrade
4 alpine 6 1/2 two way speakers
kicker 250w sub amp
2 kicker 10" subwoofers in ported enclosures
the bad
slight oil leak maybe the valve cover gasket
slight power steering leak from the rack on the passenger side, sale would include a new rack i just haven't had installed yet
no radio
would need a new radio bezel surround
convertible top needs to be recovered (doesnt leak but the stitching on the edges is weakening)
convertible top needs the motor pins fixed, motors work but won't lift the top without the stress pins replaced
check engine light on for egr insufficient flow since the header was installed.
catalytic converter was straight piped (only bad if you need to inspect for emissions)
pics can be found on my project page linked on my signature
top is currently tan after replacing the convertible top frame
This post has been edited by b22ri22an: Feb 13, 2014 - 2:15 PM
