Over 1M Posts • 84K Topics • 9K Authors

Home > Topic #92099

3sgte Japan vs Euro ECU-wiring - 6G Celicas Forums

Topic #92099 4 posts Started by skogs
skogs
#1
I'm swapping a 3sgte from a rhd st205 to a lhd st205. My mechanic says that the wiring in my car has been tampered with, and is useless. Is it possible to use the entire ecu-wiring harness from the rhd if i just extend the cables a bit?

This is the problem:




This post has been edited by skogs: Mar 3, 2014 - 8:48 AM
mkernz22
#2
>
QUOTE (skogs @ Mar 3, 2014 - 8:41 AM) *
>I'm swapping a 3sgte from a rhd st205 to a lhd st205. My mechanic says that the wiring in my car has been tampered with, and is useless. Is it possible to use the entire ecu-wiring harness from the rhd if i just extend the cables a bit?

This is the problem:




Yes, you can extend the wiring and use it. Stick with the JDM ecu too cause you get a few more HP out of it because of the tune on the ECU
skogs
#3
Can i simply replace my stock ECU with the jdm ECU? Without any further adjustments?
mkernz22
#4
>
QUOTE (skogs @ Mar 29, 2014 - 1:07 PM) *
>Can i simply replace my stock ECU with the jdm ECU? Without any further adjustments?


You should be able to since it's for the same engine.
Not sure if someone else can chime in on this?
← Back to Topics