Jmk91

#1

Going to be using a non air bag steering wheel but I do not want my SRS light on in my dash if it will even come on. I'd think it would.

Box

#2

Remove the bulb.

---

2001 Miata LS 5-speed

Jmk91

#3

Hahaha I feel stupid now.

mkernz22

#4

Remove the lower center console, part with the ash tray / cup holders. The airbag ecu is under there, just unplug it and put everything back together.

TRDweaponX

#5

mkernz22 will the light stay off even with the steering wheel air bag missing? I would still like my passenger side air bag to work if at all possible. I was going to try and figure out which resistor I need to trick the computer.

njccmd2002

#6

>

QUOTE (TRDweaponX @ Apr 28, 2015 - 10:40 AM)

>mkernz22 will the light stay off even with the steering wheel air bag missing? I would still like my passenger side air bag to work if at all possible. I was going to try and figure out which resistor I need to trick the computer.

Dont do it. Not with airbags. You can make one explode and injure someone.

---

Learned a lot in 10 years...I hardly log in anymore, last loginToday Sept 6 2019, and I was forced just to clarify a post. LOLIf you PM me and I dont respond, dont fret or cry. Im alive, better post your questions in the thread below, maybe I log back in2grfe Swapped...Why I chose the 2GR, before you ask read here...A great civilization is not conquered from without until it has destroyed itself from within.@llamaraxing in Instagram is the best way to find me. I hardly log here anymore.

TRDweaponX

#7

I've seen some kits for other vehicles that come with a plug that turns the light off.

This post has been edited by TRDweaponX: May 2, 2015 - 8:56 AM

FunkySR

#8

DO not unplug anything from anywhere.

Y ou only need to unplug the driver's airbag and connect a 3.3 Ohm resistor across the 2 terminals in the loom.

http://www.ebay.co.uk/itm/TOYOTA-3-3-OHMS-...=item3ce492d390

Hope this helps,

J