so i realized the exhaust i had was a single piece i dont know why exhaust shops do this crap...
and when i took it off the car, i already had cut it in two pieces....
too long, to put in, and to service... needed to add flanges...
ebay is a good source.
all you need is a angle grinder with a cutting wheel, an abrasive wheel, and a MIG welder.... If you can borrow a MIG, do it, learn. Save money....
best way to cut a pipe, with a grinder, is to clamp it. it serves as a guide, even when you use the abrasive disc to remove edges..
first piece is done.. did not put the process of welding, that is boring..
If you see, i also did the tail pipe...
use the abrasive wheel to smooth it out and to prepare for welding.
then weld...
i used barbeque paint to protect the welds...
enjoy....
and when i took it off the car, i already had cut it in two pieces....
too long, to put in, and to service... needed to add flanges...
ebay is a good source.
all you need is a angle grinder with a cutting wheel, an abrasive wheel, and a MIG welder.... If you can borrow a MIG, do it, learn. Save money....
best way to cut a pipe, with a grinder, is to clamp it. it serves as a guide, even when you use the abrasive disc to remove edges..
first piece is done.. did not put the process of welding, that is boring..
If you see, i also did the tail pipe...
use the abrasive wheel to smooth it out and to prepare for welding.
then weld...
i used barbeque paint to protect the welds...
enjoy....
Learned a lot in 10 years...I hardly log in anymore, last loginToday Sept 6 2019, and I was forced just to clarify a post. LOLIf you PM me and I dont respond, dont fret or cry. Im alive, better post your questions in the thread below, maybe I log back in2grfe Swapped...Why I chose the 2GR, before you ask read here...A great civilization is not conquered from without until it has destroyed itself from within.@llamaraxing in Instagram is the best way to find me. I hardly log here anymore.