If my girlfriend was expecting, the last thing I would be doing is spending money on my car. That excuse would go over like a fart in church.
Better idea: tell them my girlfriend will make them lumpia.
1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of moneyI'm not really an asshole, but I play one on the internet.**** Photobucket
Loempia > what I said. Man I love me some Indonesian...
Glad you agree, I read it in a book titled "Never Be Lied To Again" and thought it was the biggest crock of sh!t available.
On another note, how is the placement and balance versus the old 5S, any weight distribution change?
This post has been edited by SwissFerdi: Apr 11, 2011 - 7:57 PM
'97 ST\ Eibach \ KYB \ Kenwood \ Alpine \ Cusco \ OEM+[sold 10/18]'93 MX-5LE
Doesn't seem like any weight distribution change. The passenger side has always sat lower than the driver's side. When I installed the coilovers in the rear the driver's side sat up significantly higher than the passenger side - I ended up needing to lower the driver's side rear and raise the driver's side front to get it to equal out side to side.
1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of moneyI'm not really an asshole, but I play one on the internet.**** Photobucket
get it corner weighted and adjusted.
2000 Celica GTS 'slowest gts evar'1998 Mazda 626 FS-DE/CD4-E
thing looks sickk broo, sounds beastlyy, good work!
st205 powered ss3 coupe
Visit My WebsiteI was curious to know if you were able to figure out what this is.
Im also swapping a 1mzfe into my NA MR2. 91 red, just like yours. and I got a WRX, Im a systems admin as well.
Weird. Anyways check it out. Im concerned. Its from a 2000 ES 300. VVT-i with 2001 NON VVT-i heads..
Tell me your thoughts.
somebody is pulling your leg..
Learned a lot in 10 years...I hardly log in anymore, last loginToday Sept 6 2019, and I was forced just to clarify a post. LOLIf you PM me and I dont respond, dont fret or cry. Im alive, better post your questions in the thread below, maybe I log back in2grfe Swapped...Why I chose the 2GR, before you ask read here...A great civilization is not conquered from without until it has destroyed itself from within.@llamaraxing in Instagram is the best way to find me. I hardly log here anymore.
Like others on the MR2 boards - It looks like an oil passageway.
Shop wasn't able to get to it this week. No problem. It just allows for more goodies to be here in time for the unveiling.
Ordered Cusco OS strut bars for the front and rear.
1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of moneyI'm not really an asshole, but I play one on the internet.**** Photobucket
Just left the shop
They're just getting started on it after one guy being gone all last week. I went in and showed them what I need.
They're going to cut the front mount apart, and bolt the plate to the wall, then bolt the mount to the engine, and tack the mount together. Easy peasy. The bulk of my concerns just went right out the window
I had a picture of the B-pipe that Brad Bedell had made for his V6 MR2 (the guy who made my headers) and I sent that to the mechanic so he knows how to do up the exhaust.
He also noticed that the EGR cooler plate on the backside of the motor was leaking a little coolant, so he's going to take care of it.
Should have it back at the end of this week! OM NOM
1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of moneyI'm not really an asshole, but I play one on the internet.**** Photobucket
Picked the car up this afternoon. Decided a good shakedown run would be to drive it from Enumclaw to Seattle (~30 miles) and back.
Findings on this shakedown run:
- I need to raise the front end a bit and turn up the stiffness on the coilovers, as it is presently set to the softest setting.
- I can smell gas, but I don't have a gas leak. Need to investigate. Probably an improperly ran vacuum line.
Other than that it was solid. It pulls well in all gears at any point in the RPM range. The exhaust isn't too loud unless I really get on it, and it has a hint of rasp due to the headers and lack of a catalytic converter.
OMG. Torque! Mwahahaha. I will get some videos up tomorrow.
1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of moneyI'm not really an asshole, but I play one on the internet.**** Photobucket
taking too long to mod since '09June '12 COTM'95 AT200
>
QUOTE (HectortheRican @ Apr 23, 2011 - 1:24 AM)
>FCUK YEAH!!!!
x2!
Can't wait to see the videos and congratulations on completion of an incredible project.
Has no more Celicas
Found the source of the gas smell - bad o-rings on the front bank injectors. Replacing the o-rings in about 30 minutes.
Pics and video will wait until tonight. My camera is in the lady's tC.
1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of moneyI'm not really an asshole, but I play one on the internet.**** Photobucket
2000 Celica GTS 'slowest gts evar'1998 Mazda 626 FS-DE/CD4-E
Replaced the o-rings, and the leak got worse.
what was first a small leak was now a fountain!
I then realized I did not lube the o-rings or grommets with oil beforehand, and I had pinched one and snapped it. Replaced them all over again and no more leak!
Took it for a long drive and dialed in the suspension. All the way hard in the front, and 5 clicks back from hard in the rear. No more rubbing. I need an alignment still to straighten my steering wheel and to take the caster out of the passenger front. The tire is sticking out past the fender and rubs just a little on bumpy turns. Once I can put a couple degrees of camber I'll be golden.
The Mrs. gets off work at 6:30 (Pacific time) and we'll be getting some videos posted.
So happy!!!!
1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of moneyI'm not really an asshole, but I play one on the internet.**** Photobucket
Nevermind me slipping the clutch - I'm still trying to get used to the heavier clutch and lightweight flywheel.
http://www.youtube.com/watch?v=yzgwiux6g8U
This post has been edited by 95CelicaST: Apr 23, 2011 - 10:17 PM
1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of moneyI'm not really an asshole, but I play one on the internet.**** Photobucket
Now that's a fine amount of torque.
Sounds good, pulls great, and very unique. Well done.
Compared to the old engine does it throw you back in your seat?
Has no more Celicas
Oh yeah, definitely. It was weird being in 4th gear just cruising around and pressing the pedal to the floor used to cause the 5S to make a lot of noise without much acceleration. Now when I put my foot to the floor in 4th gear I get pushed back in my seat and it rockets forward.
To give you an idea - that clip is a 0 to ~ 70mph run. I let off right as I went around the corner out of sight... and that's with me slipping the clutch. Its quick. I recommend this swap to anyone!
1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of moneyI'm not really an asshole, but I play one on the internet.**** Photobucket
Sounds quite good indeed, looks fast for sure. Walkaround video, moar video in general? I'm need moar.
Congratulations though.
'97 ST\ Eibach \ KYB \ Kenwood \ Alpine \ Cusco \ OEM+[sold 10/18]'93 MX-5LE
Moar will come this morning. I will do a walk around just for you. Haha.
1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of moneyI'm not really an asshole, but I play one on the internet.**** Photobucket
Promise to include a maniacal laugh or two, a la first start-up video.
'97 ST\ Eibach \ KYB \ Kenwood \ Alpine \ Cusco \ OEM+[sold 10/18]'93 MX-5LE
I'll see what I can do.
Raised the front end this morning. Fixed the mad caster on the front passenger wheel and got the wheel straightened out a bit. Turns out my car came from the dealer with a front bra - I found all of the snap buttons in the wheel well... and promptly removed them all.
Before:
After:
1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of moneyI'm not really an asshole, but I play one on the internet.**** Photobucket
Caution: Annoying noise ahead. Adjust speakers accordingly.
So this started happening this morning while I was out and about. It's RPM dependent, but it doesn't affect power or anything. Once I get up in the RPMs it seems to go away, or quiet down. I was thinking maybe the alternator belt because its wet out today which it hasn't been since its been running. The only problem with that theory is that it doesn't sound like any wet or loose alternator belt I've ever heard.
Ideas? Swiss, this is your fault. This is why we can't have nice things!
1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of moneyI'm not really an asshole, but I play one on the internet.**** Photobucket
Holy shetballs, you weren't kidding. Wow that's irritating.
This post has been edited by SwissFerdi: Apr 24, 2011 - 1:25 PM
'97 ST\ Eibach \ KYB \ Kenwood \ Alpine \ Cusco \ OEM+[sold 10/18]'93 MX-5LE
Pulled the alternator belt and started it to see if it was the bearing in there, but the noise still exists. It sounds like a high pitch air leak.
1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of moneyI'm not really an asshole, but I play one on the internet.**** Photobucket
Check that the timing belt or pulley isn't rubbing on a timing cover, sort of sounds like it could be.
2000 Celica GTS 'slowest gts evar'1998 Mazda 626 FS-DE/CD4-E
Not the timing belt - its sitting fine on the cam gears, but it does sound like its coming from that side of the motor. Idk. This is a tad frustrating...
1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of moneyI'm not really an asshole, but I play one on the internet.**** Photobucket
The idea of low coolant was brought up, but the coolant level is full.
I think I'm just going to take it back to my shop and let them tear into it. They have the tools and time to take care of it quickly.
1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of moneyI'm not really an asshole, but I play one on the internet.**** Photobucket
Problem found. Its the riveted plate on the 4v6 mount vibrating.
1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of moneyI'm not really an asshole, but I play one on the internet.**** Photobucket
>
QUOTE (95CelicaST @ Apr 24, 2011 - 6:47 PM)
>Problem found. Its the riveted plate on the 4v6 mount vibrating.
Great detective work. What was your solution to that problem?
Has no more Celicas
