Engine/Transmission/Maintenance

14,249 Total Topics
25 Showing
51 Page 51 of 570
Topics in Engine/Transmission/Maintenance • newest topics first
1 posts • Started by didikong169
Hey Guys im new here i need help i have a 97 2.2 manual and its not starting it turns over just fine but it wont fire thinking its a fuel problem idea...
4 posts • Started by Red123
Are you looking for something already done by someone, so you can use the same or want complete personal? Just go to your local decal shop and tell th...
3 posts • Started by medina95gt
I have a 95 Celica gt that has a f*$%&$# engine due to me driving it when a "rod knock". So my question is any one know a good yet not expensive mecha...
2 posts • Started by fiddler69
Fortunately all of the plugs are unique to each other and will only plug into the correct receptacle. Except for maybe the fuel injectors....
8 posts • Started by onnaj
Each cable is secured with a c-clip to a bracket on top of the gearbox. The ends are connected to the linkage via a rod and pin....
9 posts • Started by Bitter
Could just be a matter of needing a tuneup. Check compression across the cylinders, if that checks out the engine is fine and it's something menial....
2 posts • Started by Pfloyd09
A few weeks ago my shifter suddenly became difficult to move, and now I have to push it about half a notch forward to get it into the right spot to dr...
14 posts • Started by JuniorJoe
...aaaaand the trans is out! tomorrow: replace the clutch, and do it all again, in reverse. man, that's a "light" transmission......
16 posts • Started by BonzaiCelica
Back from the dead! So the 5S/S54 axels are what, exactly? Too short to use with the E56? The inner driverside axel fit inside the housing, I tested b...
9 posts • Started by 6strngs
alternator or a short somewhere......you just used a bandaid....
20 posts • Started by BonzaiCelica
A tooth off wont cause cause valve damage. I'm pretty sure the 3sge is a non-inteference engine. BEAMS may be interference, but not the 3rd gen. So...
2 posts • Started by gts4
Just took apart my hood latch. Hood closes and locks intermittently. I took apart the whole assembly. 3 10mm bolts, 2 springs, and some metal. I left ...
3 posts • Started by dano5478
\ This post has been edited by Roadrash : Sep 11, 2013 - 12:37 AM...
6 posts • Started by Box
Hi so i'm new to all this, i just got my 94 celica st about a month ago due to me getting in a wreck with my other car and i'm more than happy with th...
2 posts • Started by Red123
Hello guys. Do you know what are the size of these hoses?...
6 posts • Started by Bitter
2.2l, 5sfe. Battery has yellow and blue corrosion or build up. Almost looks like dry foam. I used booster cables with a new car and tried a battery pa...
1 posts • Started by mi645
hello everyone I need some advice im going to check out this 3sge near my house locally and the guy basically told me over the phone hes trying to get...
27 posts • Started by 6strngs
^That. Then you'll know for sure what's going on....
2 posts • Started by jakester136
Check your fluid level first. If this is good, it may be a bad shift solenoid. but don't just throw money at parts. Take it to a tranny shop and have ...
20 posts • Started by Batman722
ARGHHHHH!!! I really did it now. I decided to yank the plug on the coolant temp sensor (the one near the throttle body), with the car running. The CEL...
4 posts • Started by Bitter
First off the 3S-GE & 3S-GTE oil pump are the same part, so there wont be any gains there The usual questions, how much money have you got to spent on...
5 posts • Started by ILoveMySilly97
Can you tell the general are the sound is coming from?...
3 posts • Started by DouglasJaneway
So, I could tell my fuel pump was getting bad, so I replaced it. I fould a good deal on an AC Delco one and swapped it. It seems to work great on norm...
3 posts • Started by mgnt232
A picture of the assembly would've been nice, but good job! Will find this useful when I replace my pump....