Engine/Transmission/Maintenance
14,249
Total Topics
25
Showing
34
Page 34 of 570
Topics in Engine/Transmission/Maintenance •
newest topics first
I've been waiting for someone with more hands-on experience to reply, but I'll share the modest knowledge I have of the E153. It's heavier than the S5...
Blocks are very close but not exactly the same. Small differences exist. The only way you can drop compression enough to run a turbo would be to use l...
Check our buy/sell section, local junk car yards & ebay
A used JDM cylinder head?...
Been looking around for some exhaust set ups and was wondering if any one could help me on this. I was looking at the cat bac set up and saw some GT4 ...
Apexi makes a 60mm inner diameter gasket that I bought for my fujitsubo st202 exhaust. Stock exhaust for all 3sge motors are 57mm inner diameter.
Sinc...
Gonna have to go aftermarket, create an entirely custom wiring harness, and have it run on the dyno for a custom map. Expect to spend well over $1000....
At least it kinda runs again....
5S applications have an oil cooler because it combated sludge and varnish issues, 7A's seem to have those issues as well. A factory style oil cooler i...
^ what he said. Vac leak. Time to go feeling around!...
Can soak the cat in how Dawn water, cleared one out that way before. The exhaust smelled pretty for a minute or two after putting it all back togethe...
also I've found out that you can use your laptop with a usb to odb2 cable that costs $25 on ebay. you just need the totyota techstream software. which...
Hi, i want to swap the engine in my 1997 celica st. I was just wondering is this possible? If so what could I swap it to?...
Getting ready to start making purchases for my new exhaust. I've seen a couple days for people here who have run under axle exhaust set ups and I'm wo...
And disconnect the fuel filter under the hood, then slip a hose over the line and run it to a gas can.
Old gas is great for killing weeds....
Hi guys,
I've decided that I'm keeping my Celica (st204) and will very likely be looking at doing an engine swap.
I was thinking a beams red top but t...
Exactly. There have been a few manifolds listed here in New Zealand falsely listed as beams 3sgte ST205 turbo manifolds...
I have a 97 at200 hatchback and the transmission blew, and the transmission blew, my question is will the transmission from a 96 to 99 (A245E)drop int...
Are you sure the cable housings are properly inserted at both ends? Did you reinstall the U shaped clips? That would be the first thing I would check....
a bunch of transmssions use full synchromesh. don't be scared of it as your only fluid. This the only thing in the nv3500 found in every manual s-10...
Forgot to ask:
Can a GT radiator be used in a ST? If water hoses were re-routed?
Your photos show ST is small and GT is larger, but are they so differ...
Does the air Temperature sensor need to be in the actual pipe of the Short Ram intake itself (like how a MAF is inside of other intakes)?
Or can it be...
I was looking into some cam gears for my 3sge beams motor and I was wondering if these cam would able to fit right on the stock cam shafts that are in...
Also what ive found out is you can get the Toyota TIS scantech software if you know how to bittorent
http://thepiratebay.se/torrent/9618277/Toy...25_%...
Hi guys
I've got a 95 SSII with a nackered lower engine mount. I've read loads of threads on the poly inserts which as far as i can tell all came from...