Interior/Audio/Electrical/Wiring

7,599 Total Topics
25 Showing
30 Page 30 of 304
Topics in Interior/Audio/Electrical/Wiring • newest topics first
16 posts • Started by broderp
Every Toyota I've seen is like that. I've driven a few other vehicles that could have fog lights without the headlights but not a Toyota....
4 posts • Started by 3SCelica76
Does anyone have any info on this??...
4 posts • Started by Batman722
Just in time for winter I got a set of seat heaters off eBay to install in the vert. It ran me about $70 for a set of two that will heat the bottom an...
3 posts • Started by richee3
Did you put the ground strap back on the transmission? Ground issues can cause some funky problems....
5 posts • Started by dudeofchaos
I've just trimmed someone's headlining in faux suede and, as long as you take your time and lash everything with hi-temp adhesive, there's no reason i...
16 posts • Started by azian_advanced
And the side markers may come on with the headlights when I plug them , there may be some dependant circuit there. Too early to tell yet, but as far a...
11 posts • Started by broderp
Are you taking out your dash? The vent doesn't need to come out for that. So far as I can tell, it was never intended to be removed at all....
5 posts • Started by broderp
Haha, yeah, i knew about that one... plugged it in only moments after seeing it not light up the first time so it's not that... It's the driver side w...
9 posts • Started by 199celica
Drop down your windows and check the clearance...
1 posts • Started by Liam_c
Hey everyone, Currently i have the stock sound system (soon about to change ) Does anyone know what impedance and power output of the headunit is to t...
2 posts • Started by derickscrape
ok so dropping the column is the best and fastest way,even bein careful it took me less than an hour to remove it.now i have the switch in hand,i can ...
7 posts • Started by FrankB2
hey all... never messed with a vert before, what would be the way to fix the top not going down automatically, and having to do it manually?...
6 posts • Started by antonioguy
Alternator is fine. Started the car, disconnected the battery it stayed running strong. I did check for ground issues around the battery but I'm not r...
2 posts • Started by MotoFoo86
Looks like i'm doing this the hard way! Drat!...
22 posts • Started by delusionz
A while back I installed a spree dash kit and while all the bulbs worked fine the light didn't pass through the switches. My question is did any celic...
3 posts • Started by soulshadow
I drilled mine decades ago and man did it look like crap with the pillars taken off. This post has been edited by soulshadow : Nov 30, 2012 - 3:38 AM...
8 posts • Started by richee3
All the switches I've seen for the '98-99 steering wheel manage to fall apart and lose that metal piece. If you still have it, you should be able to g...
47 posts • Started by Bitter
@ broderp- Yeah all the chips are on the same power supply(the battery/alternator). The TTL chips can handle 12volts easy, but they are sloppy about i...
4 posts • Started by Fuzzyfo
Check for electrical shorts, loose wires, corroded connections, damaged insulation....
3 posts • Started by Insanity
It sounds like one or more of the wires melted, causing a short. I couldn't tell you where to begin looking though, either on the compressor itself an...
5 posts • Started by njccmd2002
i just bought some ply 8 inch 3 way speakers... i hope they sound good...
2 posts • Started by njccmd2002
error This post has been edited by njccmd2002 : Dec 11, 2012 - 6:35 PM...
13 posts • Started by clownpRon
^This. Got to it before I did. Or if you get one with a clamp you can just clamp it around your ground cable....
4 posts • Started by JDM_Factory
cool story bro...
9 posts • Started by 95CelicaST
Battery is fried, check fuses, and replace the ground wire to the battery, as it is likely melted a bit....